Open AccessPeer ReviewedPublished Monthly Since 2007 Vol. 19, Issue 12 · November 2026Media Kitinfo@guident.net

Endocrown: An Alternative Approach for Post Endodontic Restoration in Molars

  • Dr. Sneha MannP.G. Student
  • Dr. Sunil KumarReader
  • Dr. Rohit PaulProfessor & HOD

Department of Conservative Dentistry & Endodontics, K. D. Dental College & Hospital, Mathura

Guident · Volume 13, Issue 6 (May 2020)Published May 20206 min read6 figures

INTRODUCTION

Traditionally the gold standard for the restoration of endodontically treated teeth (ETT) has been all metal, metal-ceramic or all-ceramic full coverage crowns.1 In the recent years, emphasis has been given to tooth tissue preservation and this principle also apply to ETT.2
Pissis introduced the monoblock heat pressed ceramic technique in 1995. The technique utilized the pulp chamber to increase macromechanical retention of crown.3 Bindl and Mörman evolved the proposal by Pissis in 1999 and named it ‘endocrown’. They described it as a CAD/CAM all ceramic crown, macromechanically anchored to the internal portion of the pulp chamber and adhesively cemented to the remaining tooth structure, gaining micromechanical retention.4
Endocrown is indicated in cases of extensive loss of the crown tissue, limited interproximal space and when rehabilitation with post and crown is not possible.5 Low cost, short preparation time, ease of application, minimal chair side time and aesthetic properties are the advantages of endocrowns.6
The guidelines for tooth preparation for an endocrown include(6) :

1. Overall reduction of 2mm in height is necessary
2. Butt joint margin of 1-1.2 mm is suggested, but not always needed
3. Occlusal divergence of 5-7 degree is obligatory for the coronal pulp chamber
4. Cervical margins should be placed as supragingivally as possible.

CASE REPORT

A 45 year old female reported to the Department of Conservative Dentistry and Endodontics with the complain of pain in upper right back region of jaw since past 2 months. Tooth was tender on percussion. Clinical and radiographic evaluation showed deep occlusal caries involving the pulp.

The tooth was treated endodontically. Endocrown was decided as the post endodontic restoration.
Gutta percha was removed to a depth of 1mm and the root canal orifices and pulp floor was lined with glass ionomer cement.
Endocrown preparation consisted of a circumferential depth of 1.2 mm. The cervical margin was supragingival. A cylindrical-conical diamond bur with an occlusal convergence of 7° was used to create continuity between coronal pulp chamber and endodontic access cavity.
The endocrown was fabricated using CAD-CAM technology in the laboratory. A try-in of the endocrown done and checked for any occlusal, internal and proximal adjustments and was sent to the laboratory for glaze application.
In the following session, the internal surface of endocrown was etched with hydrofluoric acid and rinsed with water and dried with air syringe. A coat of a silane coupling agent was applied for 1 minute and dried. The tooth surface was etched with phosphoric acid for 15 sec on dentin and 30 sec on enamel, then washed and dried. Adhesive was applied and polymerised for 20 sec with light curing.
Dual polymerizing resin was applied to the endocrown and then inserted into the tooth and polymerized for 60 seconds on all surfaces. The restoration was examined for any occlusal interference.

Clinical figure

FIGURE 1-Endodontically treated maxillary molar

Clinical figure

FIGURE 2-Root canal orifices and Pulpal floor lined with GIC

Clinical figure

FIGURE 3-Tooth Preparation for Endocrown

Clinical figure

FIGURE 4-Occlusal view of cemented crown

Clinical figure

FIGURE 5- MAXILLARY AND MANDIBULAR TEETH IN OCCLUSION

Clinical figure

FIGURE 6-Post treatment Radiograph

DISCUSSION

Restoration of teeth that have undergone endodontic treatment is one of the most challenging aspect for the dentist and is widely debated. Conventional crowns are still considered as a restorative option but the invasive protocol for tooth preparation is criticized widely. With the introduction of adhesive materials, the range of restorative options have increased. Restorative options utilizing adhesive materials are a more conservative and cost effective treatment.7,8
The restorative treatment of molars is challenging, particularly is cases of large coronal destruction.
Endocrown is made of ceramic or composite material and is a partial crown. It is cemented with resin cement. It provide complete occlusal coverage. The adhesive surface area is increased with the pulp chamber. Composite resin, composite hybrid resin, feldspathic and glass ceramic and CAD/CAM ceramic can be used for its fabrication.6,9
The principles for the preparation of endocrown is similar to the preparation principles followed for indirect inlays and onlays.The depth, extension, and inclination of the pulp chamber wall are utilized to improve the retention and stability of the restoration.2
Indications of endocrown include small intermaxillary spaces where metal pegs and crowns can not be given because of insufficient thickness of ceramic material, where the use of posts is contraindicated and in extensive loss of tooth structure.10
The advantages of endocrown include easy procedure, less time for fabrication and good esthetics. Endocrowns have also shown better mechanical performance than conventional crowns. The advantages of ceramic like biocompatibility and biomimicry and its wear coefficient can also be utilized. Also, the single interface of a 1-piece restoration makes cohesion better.11
However, it is not indicated when adhesion cannot be assured,the pulp chamber depth is less than 3 mm, or when the width of the cervical margin is less than 2 mm for most of its circumference. The cavity of the pulp chamber provides stability and retention. It is triangular shape in maxillary molars and trapezoidal shape in mandibular molars and increases the stability.The saddle form of the pulp floor also increases the restoration’s stability.12
The compressive stresses are distributed over the walls of the pulp chamber and the cervical butt joint and reduced.13
Dual cure resin cement (CALIBRA)was used in this case. The combination of two polymerization mechanisms, light and chemical, guarantees polymerization under no light conditions.

CONCLUSION

Post endodontic restoration of a maxillary molar with an all-ceramic endocrown presented with good results. Endocrown can be considered an alternative treatment for endodontically treated teeth. It adheres to the new concept of minimal intervention dentistry.
This reconstruction, though still not common, should be understood and practiced.


REFERENCES

  1. Dietschi D, Duc O, Krejci I, Sadan A. Biomechanical considerations for the restoration of endodontically treated teeth: a systematic review of the literature, part II (evaluation of fatigue behavior, interfaces, and in vivo studies) Quintessence Int. 2008; 39: 117–129.
  2. Rocca GT, Krejci I. Crown and post-free adhesive restorations for endodontically treated posterior teeth: from direct composite to endocrowns. Eur J Esthet Dent. 2013; 8: 156–179.
  3. Pissis P. Fabrication of a metal-free ceramic restoration utilizing the monobloc technique. Pract Periodontics Aesthet Dent. 1995; 7: 83–94.
  4. Bindl A, Mörmann WH. Clinical evaluation of adhesively placed Cerec endo-crowns after 2 years--preliminary results. J Adhes Dent. 1999; 1:255–265.
  5. Chang CY, Kuo JS, Lin YS, Chang YH. Fracture resistance and failure modes of CEREC endo-crowns and conventional post and core-supported CEREC crowns. J Dent Sci 2009; 4(3): 110–7. 10.1016/S1991-7902(09)60016-7
  6. Dietschi D, Duc O, Krejci I, Sadan A. Biomechanical considerations for the restoration of endodontically treated teeth: a systematic review of the literature, Part II (Evaluation of fatigue behavior, interfaces, and in vivo studies). Quintessence Int 2008. February; 39(2): 117–29.
  7. Rocca GT, Bonnafous F, Rizcalla N, Krejci I. A technique to improve the esthetic aspects of CAD/CAM composite resin restorations. J Prosthet Dent 2010; 104:273-5.
  8. Bindl A, Richter B, Mörmann WH. Survival of ceramic computer-aided design/manufacturing crowns bonded to preparations with reduced macroretention geometry. Int J Prosthodont. 2005;18:219–224.
  9. Gohring T, Pteres OA> Restoration of endodontically treated teeth without posts. Am J Dent 2003; 16:313-7.
  10. Hargreaves M, Berman L. Cohen’s Pathways of the Pulp. 11th ed. St. Louis, Missouri: Mosby Elsevier; 2016.
  11. C. L. Lin, Y. H. Chang, C. Y. Chang, C. A. Pai, and S. F. Huang, “Finite element and Weibull analysis to estimate failure risks in the ceramic endocrown and classical crown for endodontically treated maxillary premolar,” European Journal of Oral Sciences, Vol. 118, no. 1, pp. 87-93, 2010.
  12. Fages M, Bennasar B. The endocrown: a different type of all-ceramic reconstruction for molars. J Can Dent Assoc. 2013;79:d140.
  13. R. Menezes-Silva, C. A. V. Espinoza, M. T. Atta, M. F. L. Navarro, S. K. Ishikiriama, and R. F. L. Mondelli, “Endocrown: a conservative approach,” Brazilian Dental Science, vol. 19, no. 2, 2016.

Disclaimer from Guident

The views and opinions expressed in articles published in Guident are solely those of the authors and do not necessarily reflect the views of the editors, the editorial board or the publisher, Ivory India. Guident does not endorse any product, technique or treatment described. Clinical content is intended for qualified dental and medical professionals and is not a substitute for individual clinical judgement. Guident, its editors and the publisher accept no liability for any consequence arising from the use of information published in the journal.

How to cite this article

Dr. Sneha Mann, Dr. Sunil Kumar, Dr. Rohit Paul. Endocrown: An Alternative Approach for Post Endodontic Restoration in Molars. Guident. 2020 May;13(6). Available from: https://ivoryindia.in/articles/endodontics/endocrown-an-alternative-approach-for-post-endodontic-restoration-in-molars.html

Related articles

More in Endodontics

All 308 articles
Vol. 13, Issue 6 · May 2020

Pink Tooth of Murmmery-Internal Resorption

According to the Glossary of the American Association of Endodontists, resorption is defined as “a condition associated with either a physiologic or a pathologic process resulting in the…

Dr. Annil Dhingra

Vol. 13, Issue 7 · June 2020

Direct Composite Veneers: A Case Reports Series

Smile is an important feature of face predicting its attractiveness and need for esthetics will motivate patients to seek dental treatment. 1 Color, shape, and structural and position…

Dr. Muhammad Mutiur Rahman

Call for papers

Publish your clinical work in Guident

Original research, case reports and review articles are welcomed from clinicians and researchers worldwide. Every submission is assessed by the editorial board.