Open AccessPeer ReviewedPublished Monthly Since 2007 Vol. 19, Issue 12 · November 2026Media Kitinfo@guident.net
Open AccessCase ReportOrthodonticsSubscribe now

Treatment of Class II Division 1 Malocclusion with Class II Elastics

  • Dr. Siddharth MehtaAssitant Professor
  • Dr. Anjali mehtaConsultant
  • Dr. Surendra lodhaConsultant

Deparment of Orthodontics and Dentofacial Orthopedics, Manipal College of Dental Science Manipal, Karnatka, India

Guident · Volume 8, Issue 9 (August 2015)Published August 20154 min read6 figures

Authors : Dr. Siddharth Mehta, Dr. Anjali mehta, Dr. Surendra lodha.

Abstract :
This case report demonstrates treatment of a class II division 1 malocclusion patient with the use of class 2 elastics.

Key Words:Class II Malocclusion, Elastics, Pre-adjusted edgewise.

INTRODUCTION


One of the major reasons why patients seek orthodontic treatment is class 2 malocclusion. Out of the various treatment methods to treat class 2 malocclusion, class 2 elastics are one of the modality to treat malocclusion. This case report shows treatment of one such case with class 2 elastics.

CASE -REPORT


An 11-year-old patient presented with a Class II division 1 malocclusion with an increased overjet. The patient requested orthodontic treatment to improve his dental appearance. Extra oral examination revealed convex profile and posterior divergence. Intraoral examination revealed end on molar and canine relation, curve of spee of 1.5 mm, lower midline deviated to the left by 2 mm, increased overjet and deep overbite (figure 1, 2). Visual treatment objective (VTO) was positive (figure 3).

Treatment Objectives

  • Improvement in facial profile
  • Attaining Class I molar and canine relation
  • Establish normal overjet and overbite
  • Correction of lower midline.

Treatment plan

  • Fixed appliance therapy using Pre-adjusted edgewise mechanics with class 2 elastics.

TREATMENT PROGRESS


Treatment started with the placement of 0.022˝ preadjusted edgewise brackets and molar tubes (MBT Victory series, 3M, UNITEK, Monrovia, CA, USA). Treatment began with leveling and alignment with 0.016˝ NiTiarchwire (d-tech, Wagholi, Pune, India) and well-coordinated 0.018˝ stainless steel (S.S.) arch wires (A.J. Wilcock Premium Plus Australian arch wire, Whittlesea, Victoria, Australia). Class II elastics were givenon 0.019x0.025” stainless steel wire (Truforce, Ortho Technology, Inc., Tampa, USA) to correct the molar relation (figure 4). After 6 months of elastic wear, class I canine and molar relation was achieved. The patient was asked to maintain the appliance for next 3 months to check for the stability of treatment. After 3 months the appliance was debonded and a fixed lingual retainer was bonded in the lower arch and a removable Hawley,s retainer in the upper.

Clinical figure
Fig. 1: Pre treatment intra-oral and extra-oral photographs
Clinical figure
Fig. 2: Pre treatment Lateral cephalogram and Orthopantomogram
Clinical figure Clinical figure
Fig. 3: VTO Fig. 4: Class 2 elastics
Clinical figure
Fig. 5: Pre treatment intra-oral and extra-oral photographs
Clinical figure
Fig. 6: Post treatment Lateral cephalogram and Orthopantomogram

RESULTS


The first molars and canines were successfully brought into a Class-I relationship. Treatment time was 2 years. End of treatment, a proper overjet and overbite was establishedwith coincident midlines and a favorable profile change was noted at the end of treatment (figure 5, 6).

DISCUSSION


Class II elastics may be used for skeletal and/or dental Class II malocclusions, anchorage reinforcement, backward movement of the upper incisors, mandibular arch advancement, buccal tipping of retruded lower incisors, bite opening (class II/2), midline deviation correction.1, 2

The class II elastics have different effects:1, 2

  1. effects upon the maxillary arch:upper incisors are more vertical, extrusion and downward movement of anterior occlusal plane, backward movement of the upper arch, dental distalization.
  2. effects upon the mandibular arch: buccal tipping of lower incisors, forward movement of the entire mandibular arch, extrusion of the lower first molars.
  3. effects on the facial patterns: forward movement of the chin, forward movement of the mandible with a posterior rotation; The lower facial height will depend on the wearing time and the amount of elastic force used.
  4. effects on the occlusal plane:lowering of the anterior occlusal plane, sagital correction of the Class II relationship.

In our case favorable facial changes were achieved at the end of treatment with improvement in chin position.

During daytime, intermaxillary elastics have a vertical component of extrusion that is much more significant than the horizontal component, their effect being increased by the functional movements (mastication, phonation). According to the orthodontist,s prescription, they must be changed 1-2-3 times/day. During the night, intermaxillary elastics have an equivalent vertical and horizontal component. So, the patient was advised to wear elastics for 6 months preferably during the night time.

The brackets selected in this case were 0.022" slot with MBT prescription. This is because lower incisors have a greater torque of -6 degrees which can prevent flaring of lower incisors during the treatment with class II elastics. Overall, the patient was satisfied with the treatment.

CONCLUSION


Favorable esthetic results can be attained in Class II division 1 patient with class II elastics if monitored properly.The disadvantages of intermaxillary elastics are minimal and the results are optimal, with the condition of a careful diagnosis and treatment planning.

REFERENCES

  1. BratuCD, Fleser C, Glavan F.The effect of intermaxillary elasticsin orthodontic therapy. TMJ 2004;54(4):406-9.
  2. Langlade M. Optimization of Orthodontic elastics. GAC International Ed, New York, 2000.

More references are availabe on request.

Disclaimer from Guident

The views and opinions expressed in articles published in Guident are solely those of the authors and do not necessarily reflect the views of the editors, the editorial board or the publisher, Ivory India. Guident does not endorse any product, technique or treatment described. Clinical content is intended for qualified dental and medical professionals and is not a substitute for individual clinical judgement. Guident, its editors and the publisher accept no liability for any consequence arising from the use of information published in the journal.

How to cite this article

Dr. Siddharth Mehta, Dr. Anjali mehta, Dr. Surendra lodha. Treatment of Class II Division 1 Malocclusion with Class II Elastics. Guident. 2015 Aug;8(9). Available from: https://ivoryindia.in/articles/orthodontics/treatment-of-class-ii-division-1-malocclusion-with-class-ii-elastics.html

Related articles

More in Orthodontics

All 135 articles
Vol. 8, Issue 9 · August 2015

Bringing Orthodontics into the 21ST Century

THE CURRENT STATE OF THE ART IN ORTHODONTICS In the early 1970s, Andrews1 introduced the Straight Wire Appliance that permitted1st, 2nd, and 3rd order movements for teeth without wire…

Dr. Derek Mahony

Vol. 8, Issue 10 · September 2015

Dental Arch Growth and Development

It is necessary to distinguish changes induced by appliance therapy from those that occur from natural growth. Moorrees1 has pointed out that considerable individual variation in arch form…

Dr. Siddharth mehta

Call for papers

Publish your clinical work in Guident

Original research, case reports and review articles are welcomed from clinicians and researchers worldwide. Every submission is assessed by the editorial board.