Management of Curved Canals: A Dilemma
Department of Conservative Dentistry and Endodontics, Seema Dental College And Hospital, Rishikesh
INTRODUCTION
Successful endodontic therapy is largely dependent on a triad of access cavity, canal preparation, and three‑dimensional hermetically sealed obturation of the canals. Canal preparation is the most vital part of the triad that can be very challenging due to the complex morphology of the root canal system.1
Clinicians quite frequently encounter severe canal curvatures of different degrees within the roots that lead to a variety of problems including ledge formation, separation of instruments, canal blockage, and tear‑drop transportation at the apex or perforation. Anatomical variations within the complex root canal morphology are the commonest cause of endodontic treatment failure. It is, therefore, essential to have a thorough knowledge about the internal and external morphologies of teeth. A thorough assessment of the preoperative radiographs, careful and a meticulous approach can yield into a safe and a successful endodontic treatment of such teeth.2 The current case series presents interesting cases of endodontic management of curved root canal in different teeth.
CASE REPORTS
CASE 1
A 35 year old female patient reported to the Department of Conservative Dentistry and Endodontics, with the chief complaint of pain in relation to lower left back tooth region. Clinical examination revealed deep caries in relation to mandibular left third molar (tooth‑38). The tooth was mildly tender on percussion. Medical history was noncontributory. Tooth was vital when pulp sensibility tests (Electric pulp test and heat test) were conducted. The radiographic examination revealed deep caries in close approximation to pulp with respect to 38, with no signs of periapical pathosis. Apart from these findings, the tooth showed curved roots.
Root canal treatment was planned for the same. After obtaining patients consent, anaesthesia (2% Lignocaine 1:200000 Adrenaline) and under rubber dam isolation pulp space therapy was initiated using Endo access bur # 2 (Dentsply Maillefer). Working length was determined by electronic apex locator and confirmed by radiograph. No. #8, #10, #15 K hand files (Mani, Inc., Japan) were introduced with balanced force technique which maintains the instrument centrally in the canal. Special attention was given on frequent irrigation of the root canal and recapitulation. Final shaping and cleaning were carried out using HyFlex EDM rotary files (Coltene‑Whaledent, Switzerland) up to 6% 25 size of the instrument. Calcium hydroxide was used as an intracanal medicament and closed dressing was given for 12 days.
In the second visit, the canals were irrigated and obturated using 25 size 6% Gutta percha. The postendodontic restoration was done with composite resin. At 3 months recall and follow up, the patient was absolutely asymptomatic and there was no radiographic sign of any periapical disease.
CASE 2
A 23 year old female patient reported to the Department of Conservative Dentistry and Endodontics with severe pain in the upper left teeth. The patient gave a history of pain for 3 months that aggravates while sleeping and relieves after taking the medications. No significant medical history was observed. The intraoral examination revealed a decayed tooth in relation to maxillary second premolar (tooth- 25). The IOPAR revealed a radiolucency extending into the coronal pulp and periodontal widening was also observed. A final diagnosis of chronic irreversible pulpitis was established and the root canal treatment was advised.
With informed consent, local anesthesia was administered. Endodontic therapy was initiated under rubber dam isolation. The endodontic access cavity was prepared. The pulp chamber was irrigated by following standardized irrigation regimen using 3% of sodium hypochlorite, 17% ethylene diamine tetraacetic acid and physiological saline. The working length was taken with the #10 K files. Glide path was established up to the radiographic working length with subsequent instrumentation by using No. #8, #10 #15 K files. Final shaping and cleaning was carried out using Hyflex EDM rotary files upto 6% 25 size of the instrument.
In the second visit, the canals were irrigated with saline and dried with paper points. A master cone radiograph was taken with 25 size 6% Gutta percha. The cold lateral condensation method of obturation was performed. The access restoration was done with composite resin to maintain a good coronal seal.
CASE 3
A 22-year-old male reported in our department with missing tooth in relation to right upper teeth region. Intentional root canal in relation to maxillary canine and central incisor was the treatment plan. Radiograph revealed a curvature at junction of middle and apical third in relation to maxillary right canine (tooth- 13).
After anaesthesia and rubber dam isolation access cavity was prepared. A 10 # K file was precurved in accordance with the degree of curvature seen in radiograph. Working length was then confirmed using apex locator. 10# K file was reintroduced till radiographic working length followed by 15# K file which were precurved before placing to retain the original shape of the canal and prevent transportation to the apical side of the apical foramen.
With rotary ProTaper Next (Dentsply Tulsa), shaping and cleaning was achieved. X1 was used in brushing motion till the working length. Shaping of the canal was then done by X2 and X3 till the working length followed by X5. After finishing, master cone was selected and lateral obturation was done.
CASE 4
A 25 year old male patient referred to the Department with the chief complaint of severe and continuous pain in the mandibular right teeth region. The patient gave history of pain for the last 2 months and it aggrevated while sleeping and relieved only after taking the analgesics. The medical history is noncontributory. The intraoral clinical examination revealed a faulty restoration in relation to #47. The provisional diagnosis of chronic irreversible pulpitis was made based on the subjective and objective findings.
The root canal treatment was indicated and under local anesthesia access opening completed. The tentative working length was determined with No. #10 K files. The working length files have shown the curvatures in the apical portions of the mesial and distal canals. Glide path was established up to the radiographic working length using No. #8, #10 and #15 K files. Special attention was given on frequent irrigation of the root canal to avoid blockage by dentinal debris and to remove the necrotic remnants of the pulp tissue.
In the next appointment, the biomechanical preparation was completed with the ProTaper Next rotary system. The single cone obturation is completed with the 6% gutta percha points with the Apexit sealer. The permanent restoration was done with the fiber reinforced composite resin and the patient recalled after 3 months for evaluation.
DISCUSSION
There is no doubt that the preparation of curved canals presents one of the greatest challenges in endodontics and is fraught with difficulties. Only the curvatures in the mesio-distal plane can be seen on a radiograph, yet it is well known that curvatures in the bucco-lingual plane are also evident in many teeth.3
Canal curvature can be a dilacerated canal, S‑shaped canal, gradual curvature of the root, and sharp curvature in the apical third. Dilaceration was termed by Tomes and defined as a deviation in the linear relationship of a crown of a tooth to its root. The etiology of dilacerations is trauma to permanent tooth bud or idiopathic developmental disturbance.
Vertucci showed various anatomical variations in maxillary premolars and one such variation is S‑shaped canal.2 The present case series included endodontic management of a severely dilacerated molar and S‑shaped root canals of different teeth.
Knowledge of internal root anatomy guides a successful endodontic therapy. In the present case series, proper attention was directed in preoperative radiographic assessment which helped in negotiating root curvature and canal configuration. The common causes of endodontic treatment failure in cases of atypical canal anatomies are due to procedural errors such as ledge formation, fractured instruments, blockage of canal, zipping, or elbow creation.3
According to Gutmann coronal preflaring helps in easy negotiation of the entire curved canal.3 Pathfinder files are unique alternative to no. 6 and no. 8 K files. These files have reduced taper which helps in negotiating the smaller and difficult canals easily with additional benefit of rigidity and enhanced flexibility during canal negotiation. Precurving of all the hand instruments and use of smaller number files facilitates easy negotiation of canal curvature and maintenance of the shape without any procedural mishaps.3 All hand files are used with balanced force technique which has advantages of less extrusion of debris, less iatrogenic errors and maintenance of instrument centrally.5
Usage of rotary files in crown down technique helps in early flaring of coronal third and has advantages such as reduced coronal binding of the instruments, less apical extrusion of debris, and effective irrigation of apical third of the root canal.6
To avoid any misfortunes, it is highly recommended that a straight line access is gained into the canals. The preparation can then be started using a smaller diameter K file such as #08 or #10. A chelating agent such as ethylenediaminetetraacetic acid (EDTA) must be used, along with copious irrigation of the canals with sodium hypochlorite and once a file is withdrawn from the canal, it must be cleaned and recurved before it is reintroduced.11/p>
CONCLUSION
The severe root canal curvatures in the teeth need to be determined to reduce the endodontic complications. The appropriate root canal instrumentation techniques need to be selected based on the root canal anatomy, calcifications, and economic factors. In severely curved canals, the use of rotary NiTi files after making a glide path with hand stainless steel files is recommended.
REFERENCES
- Balani P, Niazi F, Rashid H. A brief review of the methods used to determine the curvature of root canals. J Res Dent 2015;3:57-63.
- Hegde MN, Lagisetti AK, Honap MN. Negotiating the bends: An endodontic management of curved canals – A case series. Endodontology 2017;29:160-3.
- Jain N, Tushar S. Curved canals: Ancestral Þ les revisited. Indian J Dent Res 2008;19:267-71.
- Ansari I, Maria R. Managing curved canals. Contemp Clin Dent 2012;3:237-41.
- Riitano F. Anatomic endodontic technology (AET) – A crown-down root canal preparation technique: Basic concepts, operative procedure and instruments. Int Endod J 2005;38:575-87.
- Patnana AK, Chugh A. Endodontic management of curved canals with protaper next: A case series. Contemp Clin Dent 2018;9:S168-72.
Disclaimer from Guident
The views and opinions expressed in articles published in Guident are solely those of the authors and do not necessarily reflect the views of the editors, the editorial board or the publisher, Ivory India. Guident does not endorse any product, technique or treatment described. Clinical content is intended for qualified dental and medical professionals and is not a substitute for individual clinical judgement. Guident, its editors and the publisher accept no liability for any consequence arising from the use of information published in the journal.
How to cite this article
Dr. Annil Dhingra, Dr. Ishita Agarwal, Dr. Shalini Sharma. Management of Curved Canals: A Dilemma. Guident. 2019 Nov;12(12). Available from: https://ivoryindia.in/articles/endodontics/management-of-curved-canals-a-dilemma.html























